Having a hard time holding onto your Analogue Pocket for those extended play sessions? Our 3D printed custom grips will help you avoid fatigue by emulating a more modern controller design. The Pocket is held in place by either two small nylon Phillips screws, or two larger nylon thumbscrews. Notes on Use:
-
P-Wing Grips were designed and tested to tolerate heat generated by the Analogue Pocket while under significant load (battery charging, maximum brightness, flash cart, etc). However, P-Wing Grips are NOT INTENDED FOR USE WHILE DOCKED.
-
The included thumbscrews are intended for those who need to remove the Pocket from the grips easily. If you prefer a cleaner look use the screw top version (you can likely get away with finger tightening these too).
-
Do not overtighten the included fasteners. If they get lost, worn, or broken, they can be replaced with PLASTIC or NYLON M4 6mm bolts or thumbscrews, available on Amazon and eBay.
-
Make sure your Pocket and the P-Wing Grip are free from dust and debris before insertion. This prevents particles getting trapped which could lead to surface scratches.
-
Be sure to insert the Pocket all the way into the grip before installing the nylon screws. The Pocket should remain slightly loose inside the grip after the screws are installed.
Disclaimer: Console modifications and accessories are provided as-is without any guarantees or warranty. In association with the product, BlueShell3D makes no warranties of any kind, either expressed or implied, including but not limited to warranties of merchantability, operational failure and/or damage as a result of end-user installation. Use of the product by a user is at the user’s risk.
